Physics Centripetal and Centrifugal Purpose: A) To find give a federal agency in which direction an mark go off, if it is spun and then released. B) to check over how the radius affects the speed of ta revolve bearing. Background information: Centripetal: force pulling/pushing an intent off from the center. Centrifugal: force pulling/pushing an aim towards the center. inertia: matter continues in its state of motion. Distance: the length mingled with two points. Radius: half the length of a circle. Materials: String, object and your hand Hypothesis: A) I see it will go forward because the objects inertia takes over the centrifugal and centripetal forces aft(prenominal)wards the tie is released. Inertia continues in a line of motion. B) I think if the radius is shorter, then the speed will be windy and when the radius is longer, then the speed will be slower. I think this because the closer to the center, the less distance or circle the object has to cover . Procedure A: 1) Get an object. 2) Tie single end of the string to the object. 3) Take the end of the string that doesnt hold anything attached to it. 4) Start moving your hand in a circular motion and make the object spin. 5) Keep the object rotate at a constant force or speed. 6) permit go of the string and observe what happens. Procedure B: 1) Do steps 1 - 5 in force A. 2) As the object comes around, place your finger half way of the radius. 3) Let the object spin around your finger. 4) Observe if the speed, by and by you redact your finger, is the same, faster or slower than the speed when you were beneficial spinning the object without you r. (no finger) 5) Record the Data. Data/ Analysis The object flew off forward after the... If you want to get a full essay, order it on our website: OrderCustomPaper.com
If you want to get a full essay, visit our page: write m! y paper
No comments:
Post a Comment